adapT5 Energy Saver

Perform an easy and inexpensive conversion of your existing T12/T8 fluorescent strip lighting to accommodate the newly developed and optimized T5 generation of light tubes.

The adapT5 Energy Saver for 110/120 Volt and 220/230 Volt conversions:

Conversions using the adapT5 adapter are suitable for T12 and T8 fluorescent light tubes operating with magnetic or conventional ballasts (CCG). Voltage ranges are 110-120 & 220-230.

Common & standard 4 foot conversions would replace 40 Watt T12 tubes with 28 Watt T5s and for 5 foot conversions, 65 Watt T12 tubes with 35 Watt T5s. Conversions can be made for 2ft to 8ft sizes.

For adapT5 conversions:

1. Remove Inefficient Starter & T8/T12 tube

2. Replace with Energy Saving adapT5

Conversion is done in only a few minutes, with no specialists required. The advantages are immediate: much lower energy consumption, improved illumination, longer maintenance intervals - resulting in significant economic savings!

Adapt to T5 with the safer adapT5

True one piece, no extra wiring or external electrical componets needed in starter socket.
White coated electrically insulated rail for prevention of hazard of electricl shock or inury.
No perilous

Improve your lighting efficiency:

More efficient warm-up phase and stable, flicker-free illumination during operation.
Optimized illumination of the workplace enhances the effectiveness and productivity of your workforce.
No perilous 50Hz stroboscopic effect and thus no flickering.

Capitalize on energy savings:

Customize and improve your lighting through the use of reflectors.
Increase the electricity/light-output ratio from 40%-50% to 80%-90%.
Energy savings of up to 70% are possible (depending on local and technical conditions).

Benefit from simple installation:

The adapT5 adapter is easily installed and fitted into existing T12 fixtures.
Straightforward removal of the conventional starter, no inefficient bridge needed.
Conversion is completed in minutes, with no specialist required.

Always protect your environment:

T5 tubes contain 38% less glass and phosphorous than T12 tubes and contain only 5mg of mercury.
No ray-emission through minimization of the electromagnetic discharge.
Low energy consumption and optimized efficiency lead to less strain on energy resources and a reduction in CO2, SO2 and NO2.
No PCB emission, thereby anticipating new, future compliance.

Benefit of cost efficiency:

Minimal installation costs.
No downtime during installation.
Significantly lower maintenance costs through much longer use life of T5 tubes with the adapT5 adapter.
Elimination of the conventional starter.
Optimal lighting conditions reduces visual strain, improving overall productivity levels.
More efficient use of energy and improved lighting standards.